What Is A Vinyl Snap Lock Punch Used For

It also works well on aluminum siding but is not recommended for steel.

What is a vinyl snap lock punch used for.

Step 6 push the top of the vinyl siding with the tabs into the utility trim just enough to hold the edge and push the bottom against the second to last piece of siding. One of those specialized tools is the snap lock tool. Punch raises a high projection to compensate for natural relaxation of vinyl plastic. A snap lock punch is used to punch lugs in the cut edges of siding to be used for the top or finishing course at the top of a wall or underneath a window fig.

If it is necessary to cut the nailing hem off the final panel use a snap lock punch to create tabs every 6 152mm along the cut edge. This tool also makes tabs in the cut edge of siding panel used as a finishing course at the top of wall or below a window. Push up gently until you hear a click. The sl5 should not be used when permatabs are required to snap into finished trim.

This way it secures vinyl siding to the completed trim at the top of the wall and under the window. Factors to consider when buying a snap lock punch tool. The hole is elongated to allow for expansion and contraction fig. Attach utility trim and insert the panel into the receiving channel.

For areas where more than one panel length is needed use a double channel lineal or back to back j channel. Nail hole slot punch occasionally it may be necessary to elongate a nail hem slot to hit a stud. The punch also works well on aluminum siding. Video of the day volume 0.

Product overview the malco snap lock punch makes tabs in the cut edge of a siding panel used as a finishing course at the top of a wall or below a window. Make tabs every 12 to 16 inches in the cut edge of the vinyl siding using a snap lock punch. For this application we reccomend using the malco sl1r or sl2r snap lock punch. Dents lock it into the utility trim that is held to the window and the edge of your house.

Snap locks plastic skirting and siding to finish trim by creating a tab in the cut edge of the siding panel. The punch raises a high projection to compensate for natural relaxation on vinyl plastic.